Connectable to a wide range of devices
Built-in Bluetooth ® wireless technology facilitates connection with a wide range of devices.
Improvement in workability with wireless connection
Because there are no cables, the GT10B can be installed anywhere (Min. 10m, with no obstractions).
Can be connected by simply scanning the bar code underneath the communication unit.
4 data-saving functions
No connection error
Multiple units can be used simultaneously by specifying where to connect.
Transmission Confirmation (planned)
Accurate data transmission possible with ACK/NAK protocol built-in.
Data Check (planned)
Error correction code included in the data helps prevent missing and substitution of the data.
Prevents scanning in the event of disconnection.
Function to notify decline in battery voltage
Buzzer and LED alarm function to warm of decline in battery voltage(planned).
An orange LED will flash at 200 mm second intervals and a buzzer will sound 5 times.
Extended operating time
Eight hours of operating time possible even with a constantBluetooth ®connection (at one scan per 5 seconds).
Battery can be charged in approx. 2.5 hrs with the exclusive unit charger (CH-GT10N).
Superior scanning performance
Realizes rapid scanning of bother 2D and bar codes (twice the speed of conventional units).
Improved scanning of poorly printed 2D code labels (Compared with other Denso models).
Divers scanning features
Target Pointer Mode
Enables pinpoint aiming and scanning, even with multiple codes in the scanning area.
Multiple Bar Code Scanning Mode
Instantly scans multiple bar codes at once.
Bar Code Reader Mode
Achieves high speed scanning equal to traditional innearscanners.
Single Scanning Mode
Realizes single scanning of QR code combinations.
World- leading impact resistance
With a stronger body and the use of impact-resistant rubber, the scanner can survive a 2 m drop-the highest standard in the world.
Superior environmental endurance
After many years of developing high quality technology, IEC International Standards Protection Class IP54 (equivalent to JIS spash resistance) has been achieved, preventing water and dust from infiltrating the scanner.
Laser illumination of scanning area and center of scannning area Tri-color Extra Bright LED
Tri-color Extra Bright LED
Tri-color LED display that shows operation status
Scan completion confirmed by vibration
Adjustable Buzzer Volume
3 levels of buzzer volume to suit the surrounding environment
Wide range of Functions
Determines if a code being scanned matches a master bar code redistered in the GT10Q.
Data Editing Function
Sorts scanned barcode data and prints out only necessary data.
Use of magic key
Wireless connection control
Wireless connection can be disconnected by pressing and holding the magic key for a few seconds. Reconnect by switching the trigger ON.
Marker swich control for easier pinpoint scanningCode type switching
Two types of code can be pre-registered to enable easy swithing between the two types of code by turning the magic key ON.
Scanning ON/OFF feature
Turn the magic key OFF to suspend scanning, and ON to resume.
Transmission of designated characters
Data that is already stored (eg operations initiation code) can be sent by switching the magic key ON.
Retransmission of scanned data
Scanned data can be retransmitted when the magic key is ON so the bar code does not need to be repeatedly scanned.
Activating and ending Bar Code Reader Mode
Operation of a single magic key activates or ends Bar Code Reader Mode.
Setup Software Easy to Install